Fridge not cooling: what to check first
Last reviewed by HomeMint Editorial3 min read
Check the temperature setting, blocked air vents and the door seal first. Dusty condenser coils are the next most common cause.
A fridge that is running but not cold enough is often an airflow problem. In most fridges, cold air is made in the freezer and blown into the fridge section, so anything that blocks that path warms the fridge up.
Start with the checks that cost nothing and keep the doors closed as much as you can while you work.
Common symptoms
- The fridge section is warm but the freezer still works
- Food spoils faster than usual
- The motor runs constantly
- The light works but nothing gets cold
- Frost building up on the back wall of the freezer
Possible causes
Temperature set too warm
Dials get bumped, and some models have a demo or showroom mode that turns the cooling off.
Blocked air vents
Food pushed against the vents at the back of the fridge or freezer stops cold air from circulating.
Door not sealing
A dirty or torn gasket, or an overfilled door bin, lets warm air in.
Dusty condenser coils
Coils covered in dust and pet hair cannot shed heat, so the fridge struggles.
A frosted-over freezer or a failing part
Heavy frost on the freezer's back wall, or a compressor that clicks on and off, needs a technician.
Safe checks you can do yourself
-
Check the settings. Set the fridge to 4°C or colder (about 3°C is a good target) and the freezer to -18°C or colder. Look in the manual for how to switch off demo mode if the lights work but nothing gets cold.
-
Clear the vents. Move food away from the vents in both compartments and avoid packing the shelves solid.
-
Test the door seal. Close the door on a sheet of paper. If it slides out with no resistance, wipe the gasket with warm soapy water and check it is seated all the way around.
-
Clean the condenser coils. Unplug the fridge. Brush or vacuum the coils behind the lower front grille or at the back. Plug it back in.
Caution: Unplug first, and do not remove any covers that are screwed on.
-
Give it room and time. Leave a few centimetres of space behind and above the fridge, then allow 24 hours for the temperature to settle.
Manufacturer information
- Your owner's manual lists the recommended temperature settings and how to switch off demo (showroom) mode, which differs by brand.
- The model number is usually on a label inside the fridge compartment, on a side wall or near the crisper drawers.
- Most manufacturers post manuals on their Canadian support sites, searchable by model number.
When to stop and call a professional
- The compressor is silent, or clicks every few minutes without starting.
- The freezer is cold but the fridge stays warm after you have cleared the vents.
- There is thick frost across the freezer's back wall.
- You notice an oily residue on the tubing or under the fridge, which can point to a refrigerant leak.
Common questions
How long is food safe in a fridge that is not cooling?
Keep the doors shut. Health Canada says an unopened fridge keeps food cold for about 4 hours, a full freezer keeps food frozen for about 48 hours, and a half-full one for about 24 hours. Throw out perishable food that has been at room temperature for 2 hours or more. When in doubt, throw it out.
Should I unplug the fridge to reset it?
Unplugging for five minutes can clear a control glitch. If it does not start cooling within a few hours afterwards, look at the other causes.
Tutorial videos
Watching someone do it helps. Look for videos from the manufacturer or an established repair channel, and check that the model shown matches yours.
Search YouTube for this repairNeed a professional in Mississauga?
If the checks above did not solve it, see local businesses from HomeMint's own list, matched on the service you need and the area they serve.
Appliance repair in MississaugaRelated guides
- Dishwasher error E24: what it means on Bosch and what to checkOn Bosch dishwashers, and the related Siemens, Neff and Gaggenau models, E24 means the machine could not drain. A blocked filter or a kinked drain hose is the usual cause.
- Air conditioner running but not cooling: safe checksA clogged furnace filter is the most common reason a central air conditioner stops cooling. Check it before anything else.
- Dryer not heating: what to check before calling for repairA blocked vent is the most common cause of a dryer that runs but does not dry, and it is also a fire risk worth fixing promptly.