Skip to content
HomeMint

Air conditioner running but not cooling: safe checks

Last reviewed by HomeMint Editorial3 min read

A clogged furnace filter is the most common reason a central air conditioner stops cooling. Check it before anything else.

Central air conditioning depends on moving a lot of air across a cold coil. When airflow drops, the coil can ice over and the house warms up even though the system sounds like it is running.

Everything below can be done without opening any panels. Anything involving refrigerant or electrical parts is a job for a licensed technician.

Common symptoms

  • Air from the vents is cool but weak, or not cool at all
  • The system runs constantly without reaching the set temperature
  • Ice on the copper line or the indoor coil
  • The outdoor unit is silent or only hums
  • Water around the furnace

Possible causes

Clogged air filter

A dirty filter starves the system of air and can freeze the indoor coil.

Thermostat setting

Set to heat, to fan-only, or with flat batteries.

Blocked outdoor unit

Leaves, grass clippings, cottonwood fluff or a cover left on from winter stop the unit from releasing heat.

Closed or blocked vents

Furniture over supply vents, or too many vents closed, reduces airflow.

Low refrigerant or a failed part

Ice on the copper lines, or an outdoor fan that is not spinning, needs a technician.

Safe checks you can do yourself

  1. Check the thermostat. Set it to cool, a few degrees below room temperature, with the fan on auto. Replace the batteries if it has them.

  2. Replace the filter. Slide the filter out of the slot beside the furnace. If you cannot see light through it, replace it with the same size.

  3. Open and clear the vents. Open every supply vent and make sure return grilles are not blocked by furniture or curtains.

  4. Clear around the outdoor unit. Remove any cover and clear leaves and debris so there is about 60 cm of open space on all sides and nothing overhanging the top. To rinse the fins, first turn the system off at the thermostat and switch off its breaker, then spray gently with a garden hose. Do not use a pressure washer or a jet nozzle.

    Caution: Do not open the unit or put anything through the grille.

  5. If you see ice, let it thaw. Switch cooling off and set the fan to on for a few hours to melt the ice, then try again with a clean filter.

  6. Check the breaker once. If the outdoor unit is completely silent, look for a tripped breaker and reset it once.

    Caution: If it trips again, leave it off and call a technician.

Manufacturer information

  • The furnace filter size is printed on the edge of the existing filter. Replace it with the same dimensions.
  • Your thermostat's manual explains its cooling settings and battery replacement.
  • In Canada, refrigerant can only be handled by certified technicians, so topping up is not a homeowner job.

When to stop and call a professional

  • Ice returns after you have replaced the filter.
  • The outdoor fan is not spinning, or the unit hums without starting.
  • The breaker trips more than once.
  • You hear hissing or see oily residue on the copper lines.

Common questions

How often should I change the furnace filter in summer?

Check it monthly during the cooling season. Most 1-inch filters need replacing every one to three months, sooner with pets or renovation dust.

Can I top up the refrigerant myself?

No. Handling refrigerant requires certification in Canada, and a system that is low has a leak that needs to be found and repaired.

Tutorial videos

Watching someone do it helps. Look for videos from the manufacturer or an established repair channel, and check that the model shown matches yours.

Search YouTube for this repair

Need a professional in Mississauga?

If the checks above did not solve it, see local businesses from HomeMint's own list, matched on the service you need and the area they serve.

Heating and cooling contractors in Mississauga

About this guide. Written by HomeMint (AI-assisted) and reviewed by HomeMint Editorial. It is general information, not a professional inspection. Appliances and homes differ: follow your owner's manual and stop if anything seems unsafe. In an emergency call 911.