Skip to content
HomeMint

Toilet keeps running: how to find and fix the cause

Last reviewed by HomeMint Editorial3 min read

Lift the tank lid and look: if water is flowing into the overflow tube, lower the float. If the level is fine, the flapper is leaking.

A running toilet is one of the most common household water wasters, and one of the easiest to fix. Everything you need to see is inside the tank, and the water in the tank is clean.

Lift the lid off carefully and set it somewhere flat; tank lids crack if dropped.

Common symptoms

  • A constant hiss or trickle from the tank
  • The toilet refills on its own every so often
  • You have to jiggle the handle to stop it
  • Water rippling in the bowl long after a flush
  • A higher water bill than usual

Possible causes

Worn flapper

The rubber flapper at the bottom of the tank hardens with age and stops sealing, so water trickles into the bowl.

Float set too high

If the water level reaches the top of the overflow tube, the fill valve never shuts off.

Chain too short or tangled

A tight or caught chain holds the flapper slightly open.

Worn fill valve

A valve that hisses constantly or will not shut off even when the float is lifted is worn out.

Safe checks you can do yourself

  1. Look at the water level. It should sit about 1 cm below the top of the overflow tube, or at the water-line mark inside the tank if there is one. If water is spilling into the tube, lower the float using its adjustment screw or clip.

  2. Check the chain. The chain should have a little slack with the flapper closed. Untangle it or move the clip one link.

  3. Do the dye test. Put a few drops of food colouring in the tank and wait 15 minutes without flushing. Colour in the bowl means the flapper is leaking.

  4. Replace the flapper. Turn the valve behind the toilet clockwise until it stops (a lever-style valve needs only a quarter turn) to shut off the water, flush to empty the tank, unclip the old flapper and fit a matching new one.

    Caution: If the shut-off valve is stuck, do not force it.

  5. Lift the float by hand. If the water keeps running even with the float lifted fully, the fill valve needs replacing.

Manufacturer information

  • Flappers and fill valves are not universal. The toilet's brand and model are often stamped inside the tank or on the underside of the lid.
  • Take the old flapper with you to the hardware store, or note the brand and whether the flush opening is 2 or 3 inches.

When to stop and call a professional

  • The shut-off valve behind the toilet will not turn or leaks.
  • Water is appearing around the base of the toilet.
  • The tank or bowl is cracked.
  • The toilet still runs after a new flapper and a correctly set float.

Common questions

Why does my toilet refill by itself every so often?

This is sometimes called a phantom flush. Water is slowly leaking past the flapper, and the fill valve tops the tank up when the level drops. A new flapper normally fixes it.

Are all flappers the same?

No. They come in 2-inch and 3-inch sizes and several styles. Take the old one, or the toilet's make and model, to the store.

Tutorial videos

Watching someone do it helps. Look for videos from the manufacturer or an established repair channel, and check that the model shown matches yours.

Search YouTube for this repair

Need a professional in Mississauga?

If the checks above did not solve it, see local businesses from HomeMint's own list, matched on the service you need and the area they serve.

Plumbers in Mississauga

About this guide. Written by HomeMint (AI-assisted) and reviewed by HomeMint Editorial. It is general information, not a professional inspection. Appliances and homes differ: follow your owner's manual and stop if anything seems unsafe. In an emergency call 911.